Beer Brewing Process And Consultant

38 0 0
                                    

1 - MASHING -
Mashing is the process of mixing milled grain (typically malted grain) with water, and heating this mixture up with rests at certain temperatures to allow enzymes in the malt to break down the starch in the grain into sugars, typically maltose.

2 - LAUTERING -
Lautering is the separation of the extracts won during mashing from the spent grain. It is achieved in either a Lauter tun, a wide vessel with a false bottom, or a mash filter, a plate-and-frame filter designed for this kind of separation. Lautering has two stages: first wort run-off, during which the extract is separated in an undiluted state from the spent grains, and sparging, in which extract which remains with the grains is rinsed off with hot water.

3 - BOILING -
Boiling the won extracts, called wort, ensures its sterility, and thus prevents a lot of infections. During the boil hops are added, which contribute bitterness, flavor, and aroma compounds to the beer, and, along with the heat of the boil, causes proteins in the wort to coagulate and the pH of the wort to fall. Finally, the vapors produced during the boil volatilize off flavors, including dimethyl sulfide precursors.
The boil must be conducted so that is it even and intense. The boil lasts between 50 and 120 minutes, depending on its intensity, the hop addition schedule, and volume of wort the brewer expects to evaporate.

4 - FERMENTING -
Modern fermenting tanks Fermentation, as a step in the brewing process, starts as soon as yeast is added to the cooled wort. This is also the point at which the product is first called beer. It is during this stage that sugars won from the malt are metabolized into alcohol and carbon dioxide.

5 - CONDITIONING -
When the sugars in the fermenting beer have been almost completely digested, the fermentation slows down and the yeast starts to settle to the bottom of the tank. At this stage, the beer is cooled to around freezing, which encourages settling of the yeast, and causes proteins to coagulate and settle out with the yeast. Unpleasant flavors such as phenolic compounds become insoluble in the cold beer, and the beer's flavor becomes smoother. During this time pressure is maintained on the tanks to prevent the beer from going flat. If the fermentation tanks have cooling jackets on them, as opposed to the whole fermentation cellar being cooled, conditioning can take place in the same tank as fermentation. Otherwise separate tanks (in a separate cellar) must be employed.

6 - FILTERING -
A mixture of diatomaceous earth and yeast after filtering .Filtering the beer stabilizes the flavor, and gives beer its polished shine and brilliance. Not all beer is filtered. Filters come in many types. Many use pre-made filtration media such as sheets or candles, while others use a fine powder made of, for example, diatomaceous earth, which is introduced into the beer and re-circulated past screens to form a filtration bed. Filters range from rough filters that remove much of the yeast and any solids (e.g. hops, grain particles) left in the beer, to filters tight enough to strain color and body from the beer. Normally used filtration ratings are divided into rough, fine and sterile. Rough filtration leaves some cloudiness in the beer, but it is noticeably clearer than unfiltered beer. Fine filtration gives a glass of beer that you could read a newspaper through, with no noticeable cloudiness. Finally, as its name implies, sterile filtration is fine enough that almost all microorganisms in the beer are removed during the filtration process.

7 - PACKAGING -
Packaging is putting the beer into the containers in which it will leave the brewery. Typically this means in kegs, but it might include bottles, cans or bulk tanks for high-volume customers.

You've reached the end of published parts.

⏰ Last updated: Nov 06, 2014 ⏰

Add this story to your Library to get notified about new parts!

Beer Brewing Process And ConsultantWhere stories live. Discover now